Ingredients, usage, precautions, safe use of aerosol products, etc.
 brand
 Hairspray Cape Za
 Element
 Ethanol, DME, LPG, (acrylamide/DMAPA acrylate/methoxy polymethyl methacrylate) copolymer, (acrylate/alkyl acrylate (C1-18)/alkyl (C1-8) acrylamide) ) Copolymer AMP, polysiloxane 9, lactic acid
 how to use
 [hair]
 Spray 20 cm or more deep from the hair

 <dot>
 Spray inward to improve retention!
 *

 Do not use with shaking ●Do not spray when using an iron or dryer. There is a danger of fire and burning.
 ●After drying, do not comb or brush your teeth. (If it passes, it will remain white.)
 ●If it is difficult to wash, please use conditioner, etc., and then rinse to loosen the hair and make shampoo easier.
 ●If the nozzle becomes dirty, wipe it clean.
 ●If it is clogged and difficult to remove, put your finger on the knob under the spray button to remove it, and then rinse the spray port of the button with hot water of about 40 degrees for at least 1 minute. After that, wipe off the water on the button, install it on the main body, and spray firmly with 5 or more presses to remove the water inside.
 >What if the liquid does not flow out easily even when the button is pressed?
 caution
 ●Do not use on abnormal areas such as wounds, swelling or eczema.
 ●Before use, please check carefully whether there is no abnormality on your skin. If this is different from your skin, or if you observe any abnormalities during use, such as redness, swelling, itching, inflammation, color difference (white spots, etc.) and darkening of the skin, or observe anything under direct sunlight For similar abnormalities, please stop using and consult a dermatologist. Continued use may worsen symptoms.
 ●Be careful not to let it get into your eyes, if it gets into your eyes or skin, please wash it off immediately.
 ●Be careful not to inhale.
 ●Do not spray on the same position for more than 1 second.
 ●Please keep this product out of reach of children.

 >First Aid SOS
 For the safe use of aerosol products
 When disposing of this product in a well-ventilated outdoor area, make sure to degas and avoid fire.
 <With exhaust cap (for exhausting residual gas)>
 [Notice]
 ●After the contents are used up, please catch a fire outdoors.
 ●Do not use products with residual ingredients, otherwise a large amount of flammable liquid will be emitted, which is dangerous.
 ●Do not use anything other than the lid of this product.

 [How to degas]
 1. Remove the label on the top of the bottle cap.
 twenty two. Remove the lid.
 3. 3. Remove spray button.
 4. Turn the jar upside down, and then firmly push the nozzle into the hole in the center of the bottle cap placed downward. (The following figure)
 5. After the ejection noise has completely disappeared, please handle it in accordance with the method specified by the municipality.

 >How to degas before handling aerosol products (video)
 <Pay attention to fire and high temperature>
 Since it is a flammable product using high-pressure gas, it is very dangerous. Please observe the following precautions.
 1. 1. Do not use near naked flames or fire sources.
 twenty two. Do not use it in large quantities in a room with fire.
 3. 3. Do not place the product in a place where the temperature exceeds 40 degrees, such as direct sunlight, near a stove or fan heater, because if the temperature is too high, there is a danger of explosion.
 4. Do not throw it into the fire.
 5. Use it up and throw it away.

 High pressure gas: DME / LP gas

 >Precautions for the safe use of aerosol products
 ●Do not put the can in a humid place, otherwise it will rust and explode.
 Alcohol (ethanol) 135ml Danger level II (pay attention to fire prevention)
 Packaging container material
 The film, bottle cap, spray button are plastic, the can is steel
 Place of origin
 Made in Japan
 Information about the release
 *Based on the information displayed on the product. (The green part is supplementary information.)
 *The display content of the latest Kao product is released, but depending on the situation, the latest product may be shipped before the update.
 *In order to prevent insufficient information, the characters in the image part can be added to the text even when listening with reading software.